I've built up a pretty good pile of small scraps of wood I just can't bear to toss over the years: verawood, ebony, rosewood, mahogany, purpleheart, but even just some nice maple, sitka spruce, red cedar, walnut, etc. I started carving some into pendants this winter, and some look pretty good, but I'm looking for ideas for really small or weirdly shaped scrap -- everything from 1/2" lathe ends with a hole in them, to long 1/2" x 3/8" x 4', a small clip of the pile under the picture.
I've heard a few people just throw them into baggies and sell/give to crafty folks, which I might do in the end. But I figure if I can make stuff to give away as gifts or sell at a craft fair, all the better... but outside of jewellery, not sure what else to do. The are NOT big enough for endgrain cutting boards, and most have a couple rounded or uneven edges.
For the lathe-end stubs, are they big enough to glue together for either bottle stoppers or maybe even small egg kaleidoscopes (with layers going up instead side-to-side)?
For the long ones, can any of them be used as pen blanks? Either top and bottom as separate pieces, or a mini-pen like this or this?
I've also seen where they trimmed down the outside of a pen blank like it was a pen (it had a top and bottom piece joined by metal), but didn't drill out the center. Instead, they drilled a small hole into the top and placed a soft alligator clip into the hole. It's to hold the end of a bracelet while you clasp the ends together.
I do recognize that each of these requires sourcing the metal, glass, etc, bits needed to complete the project, but these are the things that I thought of.
I really like the bottle stoppers. Not sure I really have anything big enough but I'm going to see what I can glue up. The bigger pieces are usually softwoods too, unfortunately, but even just carving something decorative for the top could be cool.