Context for newbies: Linux refers to network adapters (wifi cards, ethernet cards, etc.) by so called "interfaces". For the longest time, the interface names were assigned based on the type of device and the order in which the system discovered it. So, eth0, eth1, wlan0, and wwan0 are all possible interface names. This, however, can be an issue: "the order in which the system discovered it" is not deterministic, which means hardware can switch interface names across reboots. This can be a real issue for things like servers that rely on interface names staying the same.
The solution to this issue is to assign custom names based on MAC address. The MAC address is hardcoded into the network adaptor, and will not change. (There are other ways to do this as well, such as setting udev rules).
Redhat, however, found this solution too simple and instead devised their own scheme for assigning network interface names. It fails at solving the problem it was created to solve while making it much harder to type and remember interface names.
To disable predictable interface naming and switch back to the old scheme, add net.ifnames=0 and biosdevname=0 to your boot paramets.
The template for this meme is called "stop doing math".
Personally I'd do away with NetworkManager too and just configure the interfaces directly, but that might just be me being old and grumpy!
I think most distros go along because their upstream did. There are comparatively few 'top level' distributions, the main ones (by usage) being Redhat and Debian. Most everything else branches from those. Redhat's got enough clout on the market that there's a sort of pull towards complying with it just to not be left put.
I use Debian, but I think they're crazy for swallowing everything Redhat pushes, they could easily stick to the cleaner options and have a better system for it. At least they let you opt out of systemd, so life is a little more tolerable.
I'd do away with network-manager on a stationary system too, but I'm on a laptop, and unless there's some trick I don't know about, configuring wifi by hand for every new network I come across sounds like a bit of a pain. Especially for corporate/institution network that use fancy things like PEAP
If by "configuring wifi by hand" you mean writing config files by hand, that's actually not necessary with plain wpa_supplicant too. There is
wpa-gui(orwpa-cuteif you prefer Qt over GTK), which is basically a GUI frontend to wpa_supplicant, which makes adding new networks nearly as easy as with NetworkManager. But it's a far less modern looking UI than the NM frontends.Thanks for the info, I'll take a look. "far less modern looking" is a selling point for me haha. Give me those win95-looking gtk2 interfaces!