Woodworking

6971 readers

89 users here now

A handmade home for woodworkers and admirers of woodworkers. Our community icon is submitted by @1985MustangCobra@lemmy.ca whose father was inspired to start woodworking by Norm and the New Yankee Workshop.

founded 2 years ago

MODERATORS

NataliePortland@lemmy.ca

How can I saw a board into thin sheets? (feddit.org)

submitted 12 hours ago by alleycat@feddit.org to c/woodworking@lemmy.ca

11 comments fedilink hide all child comments

For a small musical instrument I need a thin sheet of spruce (1.5mm). Normally I'd just buy a guitar or lute top, but for this one I need the highest quality I can get, with very narrow rings. So my idea is to saw down a blank for a violin top (25mm at its thickest point). I need to do this with as little waste as possible, because a good spruce top can cost 100-300€.

Is there a way I can do this with hand tools?

you are viewing a single comment's thread
view the rest of the comments

[–] alleycat@feddit.org 3 points 12 hours ago* (last edited 12 hours ago)

I don't need to cut it to final thickness right away, since I have to graduate the thickness by hand anyway. Being in the ballpark of 3 or 4mm might be enough.

Edit: also, most veneers I found were plain-sawn, and I specifically need quarter-sawn.