this post was submitted on 21 May 2025
189 points (99.5% liked)

Technology

39563 readers
323 users here now

A nice place to discuss rumors, happenings, innovations, and challenges in the technology sphere. We also welcome discussions on the intersections of technology and society. If it’s technological news or discussion of technology, it probably belongs here.

Remember the overriding ethos on Beehaw: Be(e) Nice. Each user you encounter here is a person, and should be treated with kindness (even if they’re wrong, or use a Linux distro you don’t like). Personal attacks will not be tolerated.

Subcommunities on Beehaw:


This community's icon was made by Aaron Schneider, under the CC-BY-NC-SA 4.0 license.

founded 3 years ago
MODERATORS
you are viewing a single comment's thread
view the rest of the comments
[–] Vodulas@beehaw.org 9 points 1 month ago (6 children)

I don't know what you've experienced, but I have been 3d printing things for about 6 years now. With any decently tuned printer, these would be fine for the use they will get. I have the one razor they have released a part for, and the 3d printed parts are not going to experience much in the way of force that would separate the layers. It doesn't help that I don't think they followed their own guidelines when printing the examples. The layer height is huge which makes the layer lines stand out. I bet that was so they could more easily be identified as 3d printed with an FDM printer, but it looks really bad.

[–] unexposedhazard@discuss.tchncs.de 8 points 1 month ago (5 children)

I just measured the red ones original dimensions with calipers and the individual comb parts have 0.5mm at their thinnest and 1mm at their thickest. My 3D printing is not perfect, but i just dont see how that is gonna survive. Maybe i will try on the weekend and let you know how it went.

[–] Vodulas@beehaw.org 7 points 1 month ago (4 children)

I'll give it a shot too, since I have the razor for the one model they have released

https://www.printables.com/model/1289421-philips-fixables-oneblade-1-3mm-comb

[–] IrritableOcelot@beehaw.org 1 points 1 month ago (1 children)

They havent released one for the razor I have, but honestly I might try modeling them myself. Doesn't seem impossible, and I've been waning a deeper comb than they sell.

[–] Vodulas@beehaw.org 1 points 1 month ago

They aren't wildly complex, don't would be dobale for sure

load more comments (2 replies)
load more comments (2 replies)
load more comments (2 replies)