19
First Time Using A Stencil (Summercart 64) (i.imgur.com)
submitted 10 months ago by v1605@lemmy.world to c/soldering@lemmy.ca
4 comments fedilink hide all child comments

This was the first time I've used a stencil and solder paste to build up a pcb. It was so much easier to get all the components aligned and soldered on the board (on the back, there are 38 0603 capacitors which are always time consuming to hand solder). After just had to clear a few bridges and added a little extra solder to U1.

Project link

top 4 comments
sorted by: hot top controversial new old
[-] Flexaris@discuss.tchncs.de 2 points 10 months ago

Any tips on using solder paste? I tried it before but I feel like it just dried up when I heated it.

[-] v1605@lemmy.world 2 points 10 months ago

I'm not too familiar since it was my first time using it but from my research brand does matter as well as how old it is. The flux in the paste can dry out. I did notice that it worked better when I moved it around the board a lot towards the beginning, basically it was preheating so the paste melted easier. It did appear like it was drying before it went molten, so maybe your heat is not quite high enough or you're not giving it enough time.

Also, keep the air flow on the low end and angled straight down. Otherwise some components might fly off the board.

[-] j4k3@lemmy.world 2 points 10 months ago

If you happen to have photoresist and some spare etchant on hand. You can make your own stencils with a soda can. Use something like 600 grit on the outside surface, clean it shinny, don't touch the inside at all, in fact protect it with some additional packing tape while sanding the outside. Then make your pads ~30% smaller than normal to compensate for how thicker aluminum will etch into the sides and slightly circularize each hole. Then etch with anything that will work with copper. Hydrochloric acid is nice because it is clear and easy to see through. The plastic liner on the inside of the can will flake off easily once the etch goes all the way through. Soda cans are the perfect thickness, and this makes it easy to do repairs or one off prototypes, especially when you are not doing a solder mask on a tighter footprint with traces under the chip near the pads.

[-] v1605@lemmy.world 2 points 10 months ago

I'll have to keep this in mind if I ever go down the home PCB fabrication root.

this post was submitted on 24 Dec 2023
19 points (100.0% liked)

Soldering

462 readers
1 users here now

This community is for electronic hobbyists to discuss projects and is focused on soldering. Everyone is welcome from the noob to people who have been soldering as a hobby for decades to people who solder professionally. We'll talk about materials and techniques, equipment, and projects. Everyone is welcome. All questions are welcome. Post photos and ask for help.

RULES:

  1. All Lemmy.ca rules apply here.

  2. Everyone (see rule 98) is welcome.

  3. If you’ve seen a question 100 times answer it the 101st time or ignore it. Even better, write a complete, detailed answer and suggest that the mod(s) pin it to the community.

[Did you actually think there were 98 rules?]

  1. If you present something as fact and are asked to provide proof or a source provide proof or a source. Proof must be from a reliable source. If you fail to provide proof or a source your post or comment may be removed.

  2. Don’t be a dick. Yes, this is a catch-all rule.

  3. The mod(s) have the final say.

founded 1 year ago
MODERATORS
MapleEngineer@lemmy.ca