196
Soldering is getting harder. (lemmy.ca)
submitted 1 year ago* (last edited 1 year ago) by MapleEngineer@lemmy.ca to c/soldering@lemmy.ca
65 comments fedilink hide all child comments

When I started soldering everything was big and had leads that went through holes in the board. You inserted the leads, bent them over to hold the component, flipped the board over, soldered everything, and trimmed off the excess leads.

Now I'm soldering things down to 0402 SMDs (1/4 the size of the smallest component in the picture) using a needle point soldering tip and a microscope.

A pair of 2N2222 transistors, one SOT23 and one TO-92.

you are viewing a single comment's thread
view the rest of the comments
[-] MapleEngineer@lemmy.ca 1 points 1 year ago

That sucks. I've never gone that small. I ordered 0402s the first time I ordered SMDs. Now if I'm going to be soldering by hand I always order 0805s. Even those get flicked or blown away maddeningly often.

this post was submitted on 30 Jul 2023
196 points (97.1% liked)

Soldering

462 readers
1 users here now

This community is for electronic hobbyists to discuss projects and is focused on soldering. Everyone is welcome from the noob to people who have been soldering as a hobby for decades to people who solder professionally. We'll talk about materials and techniques, equipment, and projects. Everyone is welcome. All questions are welcome. Post photos and ask for help.

RULES:

  1. All Lemmy.ca rules apply here.

  2. Everyone (see rule 98) is welcome.

  3. If you’ve seen a question 100 times answer it the 101st time or ignore it. Even better, write a complete, detailed answer and suggest that the mod(s) pin it to the community.

[Did you actually think there were 98 rules?]

  1. If you present something as fact and are asked to provide proof or a source provide proof or a source. Proof must be from a reliable source. If you fail to provide proof or a source your post or comment may be removed.

  2. Don’t be a dick. Yes, this is a catch-all rule.

  3. The mod(s) have the final say.

founded 1 year ago
MODERATORS
MapleEngineer@lemmy.ca