41
submitted 3 weeks ago* (last edited 3 weeks ago) by Scrath@lemmy.dbzer0.com to c/electronics@discuss.tchncs.de

Hello everyone, I recently built a small distribution board to distribute 5V to multiple components for use in a robotics project. I made each output switchable with an individual switch and an LED to indicate the current state. When I went to test it using a lab power supply I noticed that the LEDs would start flickering weirdly when I turned them off and on again.

https://imgur.com/a/zaSCUby

As it turns out, the LEDs, which I found in my dads old parts in a bag labeled TLBO 5410, are apparently blinking LEDs. I found a datasheet for TLBR5410 LEDs which seem pretty much identical to what I have accidentally used.

Apparently these LEDs are made to operate directly from a 5V supply without an additional current limiting resistor (it is already built in) and are made to continuously blink at a frequency of 3Hz.

Because I thought I was using standard LEDs I added a series resistor causing them to behave weirdly due to low voltage. For comparison, this is how they are supposed to act: https://imgur.com/a/fXlcEDs

you are viewing a single comment's thread
view the rest of the comments
[-] ooterness@lemmy.world 8 points 3 weeks ago

There are also LEDs with a built-in "candle flicker" effect. This teardown shows how it's done with two dies integrate into the LED package: the LED and an ASIC. They also demo a circuit using a small flicker LED and an amplifier to control a much larger LED.

[-] Arghblarg@lemmy.ca 8 points 3 weeks ago

Is it true, or just a myth, that some of those cheap plastic votive candlelights actually use the same IC/circuit as musical greeting cards in order to flicker (that is, they're 'playing' some song to the LED instead of a speaker)? I forget where I heard that but thought it was a clever hack if true.

this post was submitted on 01 Dec 2024
41 points (97.7% liked)

Electronics

2080 readers
1 users here now

Projects, pictures, industry discussions and news about electronic engineering & component-level electronic circuits.

Rules

1: Be nice.

2: Be on-topic (eg: Electronic, not electrical).

3: No commercial stuff, buying, selling or valuations.

4: No circuit design or repair, tools or component questions.

5: No excessively promoting your own sites, social media, videos etc.


Ask questions in https://discuss.tchncs.de/c/askelectronics


founded 2 years ago
MODERATORS