Linux

53126 readers

971 users here now

From Wikipedia, the free encyclopedia

Linux is a family of open source Unix-like operating systems based on the Linux kernel, an operating system kernel first released on September 17, 1991 by Linus Torvalds. Linux is typically packaged in a Linux distribution (or distro for short).

Distributions include the Linux kernel and supporting system software and libraries, many of which are provided by the GNU Project. Many Linux distributions use the word "Linux" in their name, but the Free Software Foundation uses the name GNU/Linux to emphasize the importance of GNU software, causing some controversy.

Rules

Posts must be relevant to operating systems running the Linux kernel. GNU/Linux or otherwise.
No misinformation
No NSFW content
No hate speech, bigotry, etc

Related Communities

Community icon by Alpár-Etele Méder, licensed under CC BY 3.0

founded 5 years ago

MODERATORS

AgreeableLandscape@lemmy.ml

nooter692@lemmy.ml

MarcellusDrum@lemmy.ml

cypherpunks@lemmy.ml

cyclohexane@lemmy.ml

d3Xt3r@lemmy.nz

[solved] I'm having audio issues with Linux and while I have a temporary solution, I'd like to have a permanent solution if possible. (lemmy.ml)

submitted 1 week ago* (last edited 1 week ago) by vortexal@lemmy.ml to c/linux@lemmy.ml

42 comments fedilink hide all child comments

Final update (hopefully): It seems that I have been able to fix the issue. I'm not sure what exactly caused the problem but either removing fluidsynth or installing the wireplumber ppa fixed the issue and I have working audio again. I've also removed pulseaudio and undid my edit to the modprobe blacklist, as they were only done as a temporary solution and they are no longer necessary.

For the past three days, I've been having this issue where my computer starts with no audio and the only sound device listed is a "dummy output" device. I've tried looking online for solution but the only solution I found has to be redone manually every time I start/restart my computer. It also seems like this issue is common with and possibly specific to the sound card my computer has, which is an "Intel Sunrise Point-LP HD Audio".

The solution that worked for me was to add blacklist snd_soc_avs to the modprobe blacklist and then run the two commands sudo alsa force-reload and pulseaudio. Adding snd_soc_avs to the blacklist permanently brought back my actually audio devices but it didn't fix the audio nor did it remove the dummy output device. The two commands I listed do restore the audio and remove the dummy output device but they only work for the current session and I have to run them again after starting/restarting my computer.

I have no problem doing this if there isn't a permanent solution but I would like a permanent solution, if possible.

you are viewing a single comment's thread
view the rest of the comments

[–] Nemoder@lemmy.ml 2 points 1 week ago (1 children)

If it's just a matter of pulse selecting the wrong device I also had that issue and was able to work around it by adding a line to the end of my: /etc/pulse/default.pa
set-card-profile alsa_card.pci-0000_0e_00.3 output:analog-stereo+input:analog-stereo
You can get the correct name for your device with: pacmd list-sinks

[–] vortexal@lemmy.ml 2 points 1 week ago

While I have already found a working solution, I think the issue wasn't that it was selecting the wrong device. it was almost as if my normal audio devices didn't exist for some reason because nothing could see them, even my input devices were missing.