I’m hoping you guys can help me figure this out. I have an ender 3 pro, running on marlin firmware.
Every time I try to print something one of the corners will lift up like that and ruin the entire print. I installed a crtouch to help with leveling, installed upgraded metal bed wheels to help it not fall out of level. Even tried a glass bed with glue and it still does the same thing. I used a filament dryer and have a heat enclosure.
I’m starting to run out of ideas on how to fix this. Any suggestions? The pic is how it starts and that was just a brim since I used to always use a raft and thought I should try that instead.
this post was submitted on 19 Jul 2025
20 points (95.5% liked)
3DPrinting
19079 readers
144 users here now
3DPrinting is a place where makers of all skill levels and walks of life can learn about and discuss 3D printing and development of 3D printed parts and devices.
The r/functionalprint community is now located at: or !functionalprint@fedia.io
There are CAD communities available at: !cad@lemmy.world or !freecad@lemmy.ml
Rules
-
No bigotry - including racism, sexism, ableism, homophobia, transphobia, or xenophobia. Code of Conduct.
-
Be respectful, especially when disagreeing. Everyone should feel welcome here.
-
No porn (NSFW prints are acceptable but must be marked NSFW)
-
No Ads / Spamming / Guerrilla Marketing
-
Do not create links to reddit
-
If you see an issue please flag it
-
No guns
-
No injury gore posts
If you need an easy way to host pictures, https://catbox.moe/ may be an option. Be ethical about what you post and donate if you are able or use this a lot. It is just an individual hosting content, not a company. The image embedding syntax for Lemmy is 
Moderation policy: Light, mostly invisible
founded 2 years ago
MODERATORS
you are viewing a single comment's thread
view the rest of the comments
view the rest of the comments
So I gave it another try with the black filament after doing some additional adjustments and was still getting the same issues. I then swapped to a brighter filament so that I could get a better picture and now it’s laying perfectly flat. I’ll let it continue printing to see if any other issues pop up, but it’s weird that one filament was lifting but an older spool works fine.
Gave it some time to print and unfortunately it lifted up again. Going to wait for the thermometer to come in and see if that corner is heating properly