this post was submitted on 25 Jul 2026
52 points (100.0% liked)
homeassistant
20157 readers
53 users here now
Home Assistant is open source home automation that puts local control and privacy first.
Powered by a worldwide community of tinkerers and DIY enthusiasts.
Home Assistant can be self-installed on ProxMox, Raspberry Pi, or even purchased pre-installed: Home Assistant: Installation
Discussion of Home-Assistant adjacent topics is absolutely fine, within reason.
If you're not sure, DM @GreatAlbatross@feddit.uk
founded 3 years ago
MODERATORS
you are viewing a single comment's thread
view the rest of the comments
view the rest of the comments
But why install an integration when the Appliance Notifications and Actions blueprint exists?
I think the only functional difference is that Washdata attempts to infer which cycle was run, but the blueprint doesn’t have to be configured via yaml.
I have been using that blueprint for the better part of a year, and just switched to WashData last week. I can confidently say that WashData absolutely blows that blueprint clean out of the water.
The biggest thing for me regarding WashData is that it can detect when a cycle starts and ends much faster than that blueprint.
That’s possibly your detection settings or method (detection criteria, etc). My washer and dryer are separate devices on separate power monitoring plugs. The only time power draw for either goes above 2 watts is when they’re cycled on.
I just told the blueprint to wait 2 minutes before deciding a cycle has started before declaring it’s started, and 5 minutes after it has ended before sending a notification.
But I mean, I’m not here to yuck your yum. If it works for you, it works for you.
I just like seeing the data and having it categorized automatically.