Still needs some design corrections because I just didn't know how to properly do 3D print and industrial design but it works!
this post was submitted on 09 Jun 2024
10 points (100.0% liked)
CyberDeck
388 readers
1 users here now
Hey y'all, just an experiment, if it works out I'll clean it up and run it
founded 4 years ago
MODERATORS
you are viewing a single comment's thread
view the rest of the comments
view the rest of the comments
Honestly I'm not sure if my filament printer would be precise enough for key caps, maybe with a resin printer it's best.