Blandchard stone head replacement (lemmy.world)

submitted 8 months ago by AndOfTheSevenSeas@lemmy.world to c/machinist@sh.itjust.works

2 comments fedilink hide all child comments

Solid aluminum, I really really enjoyed this job

you are viewing a single comment's thread
view the rest of the comments

[-] AndOfTheSevenSeas@lemmy.world 2 points 8 months ago

I don’t mind it if it’s structural, especially too if it’s primarily mill work but I otherwise prefer iron or a higher carbon steel. And yes it is! I looked at the center drive as well but I find the vice grip much more useful than the regular pliers, and I can still use them as such fairly well.

this post was submitted on 14 Feb 2024

12 points (100.0% liked)

Machinist

669 readers

1 users here now

From Newcomers to Old Timers, a community united by the Industry of Machining

Rules Don't post illegal stuff

Don't post Porn (no sexy aluminum surface finishes don't count)

Don't be an asshat (harassment, bullying etc.)

If you're going to post NSFW stuff, flag it as NSFW, It's ok to post shop Screwups (blood/cuts) just make sure to flag it as NSFW

and Finally make sure to have a good time :D

founded 1 year ago

MODERATORS

Steamymoomilk@sh.itjust.works