Alumium is pretty fun to turn/mill its kinda sticky when cutting though. Also is that a leatherman crunch? I carry a gerber centerdrive and its comes in handy for hot chips in a pinch.
I don’t mind it if it’s structural, especially too if it’s primarily mill work but I otherwise prefer iron or a higher carbon steel. And yes it is! I looked at the center drive as well but I find the vice grip much more useful than the regular pliers, and I can still use them as such fairly well.
From Newcomers to Old Timers, a community united by the Industry of Machining
Rules Don't post illegal stuff
Don't post Porn (no sexy aluminum surface finishes don't count)
Don't be an asshat (harassment, bullying etc.)
If you're going to post NSFW stuff, flag it as NSFW, It's ok to post shop Screwups (blood/cuts) just make sure to flag it as NSFW
and Finally make sure to have a good time :D
