jig i made for easy gripping for turning the bottom side in the background.
Careful you don't go too deep.
How complex is the idea?
Not the CNC tops I was expecting.
Would you collet a top holder?
Those are really nice. How do they spin?
I got a knock-off of a fancy top from Amazon and it’s kinda tricky to get it going good without sending it flying off my desk. I would not quite call it a game of skill… but it’s not the meditative fidget I was hoping for.
Im bad at english machining words so i dont know exaclty what the top question means oof.
the aluminum one spins nicely, the brass one is too heavy to get it going.
I made the long side first cutting the top from a rod, then the second side i used that jig (the angle of the top side matches the top) and a collet stop to make the bottom side.
Sorry, it’s a really bad play on words based on the pronunciation of collet being similar to the phrase ‘call it’.
Very nice work. It’s a shame the brass top didn’t work out… perhaps a pull-cord?
From Newcomers to Old Timers, a community united by the Industry of Machining
Rules Don't post illegal stuff
Don't post Porn (no sexy aluminum surface finishes don't count)
Don't be an asshat (harassment, bullying etc.)
If you're going to post NSFW stuff, flag it as NSFW, It's ok to post shop Screwups (blood/cuts) just make sure to flag it as NSFW
and Finally make sure to have a good time :D