submitted 7 months ago by Kowowow@lemmy.ca to c/machinist@sh.itjust.works

15 comments fedilink hide all child comments

You can really see the difference few inches in

If it's stupid but it works it ain't stupid

you are viewing a single comment's thread
view the rest of the comments

[-] Wutchilli@feddit.org 1 points 4 months ago

Are you not worried that a block of wood is flying through your workshop?

[-] Kowowow@lemmy.ca 3 points 3 months ago

nah it was about 80 rpm if I remember correctly

this post was submitted on 25 May 2024

64 points (100.0% liked)

Machinist

685 readers

1 users here now

From Newcomers to Old Timers, a community united by the Industry of Machining

Rules Don't post illegal stuff

Don't post Porn (no sexy aluminum surface finishes don't count)

Don't be an asshat (harassment, bullying etc.)

If you're going to post NSFW stuff, flag it as NSFW, It's ok to post shop Screwups (blood/cuts) just make sure to flag it as NSFW

and Finally make sure to have a good time :D

founded 2 years ago

MODERATORS