33
[Weekly thread] GNU+Linux help: ask anything!
(programming.dev)
you are viewing a single comment's thread
view the rest of the comments
view the rest of the comments
this post was submitted on 01 Sep 2024
33 points (97.1% liked)
Linux
5484 readers
418 users here now
A community for everything relating to the linux operating system
Also check out !linux_memes@programming.dev
Original icon base courtesy of lewing@isc.tamu.edu and The GIMP
founded 2 years ago
MODERATORS
How do I configure my Linux, on a laptop, to consume as little battery as possible?
A bit of context: one of my laptop ran Ubuntu, with acceptable battery drain (up to 3h30 of usage, running desktop applications: Firefox, terminal, vim, etc). This is a high-end laptop: 12 AMD Ryzen + AMD Rembrandt.
I switched to open use, and now battery drains in one hour, running the exact same applications. Installed tuned, selected power save, tried power top, applied different parameters, etc, but no result: battery still dies after 1h. No improvement at all.
I am going to investigate on my own, but any help is greatly appreciated.
I assume this is an old laptop? If you're able to remove the battery, as in the old models, you can measure it's full milliamperes when at a 100%. It's probably going to show a lower value than what's reported by the user guides. From what you tell, I'd expect something as low as 1.5k... Beware that removing batteries with tools and so on might make them explode and is many times, just not an option.
Perhaps you can even see this in the BIOS. Some modern BIOS might even tell the number of charging cycles, allowing you to infer it's worn out. Chances are, you need a new battery. Which is tricky, since oftentime the "new" battery was sitting at some store but was manufactured by the company when the laptop model was fresh.
Switch the kernel power governer to power saver