Mechanical Keyboards

14080 readers

27 users here now

Are you addicted to the clicking sounds of your beautiful and impressive mechanical keyboard?
If so, this community is for you!

Here you can discuss everything about mechanical keyboards (and only mechanical keyboards).

Banner by Jay Zhang on Unsplash

founded 6 years ago

Do you use a wrist rest? (feddit.org)

submitted 5 days ago by brem@feddit.org to c/mechanicalkeyboards@lemmy.ml

19 comments fedilink hide all child comments

I recently got a Dierya 65% keyboard, and think it is rather thick.

Is this normal for a mechanical keyboard? Or is the Dierya exceptional high? Do you use a wrist rest? If so, is there anything special to look out for? Or will any wrist rest do?

you are viewing a single comment's thread
view the rest of the comments

[–] brem@feddit.org 2 points 5 days ago (2 children)

Sound I could make something my self from a piece of wood! Sand it smooth.

Good way to test the benefit of wrist rest.

[–] Nibodhika@lemmy.world 3 points 5 days ago (1 children)

I have considered that too, but I'm not sure I trust I would be able to make the wood smooth enough.

[–] MalReynolds@slrpnk.net 2 points 5 days ago (1 children)

It's not hard, but can be time consuming, break the task up. Rough out a shape in pine (soft, easy to work, make a second from hardwood later if you want once you know what you want) with chisels or whatever power tool you have access to, e.g. drill with grinder attachment (and a vise or some other way of securing the wood, screws work). Then just get different sandpaper grits and sand by hand, start with 100 or 200, then 400, then 600 or 800 and if you still don't think it's smooth enough, 1200 will get you there. Probably take a few hours, but you'll have a handy new skill, and can refine over time.

[–] luftruessel@feddit.org 2 points 5 days ago* (last edited 5 days ago) (1 children)

I agree very much with your suggestion. Just pick up some piece of wood and go for it. Nothing to loose, just pay attention and don't do anything with power tools where you don't feel save.

Only on the sandpaper I would disagree - sure you can go to 1200, but spare yourself the time. 320 is more than enough in most cases.

[–] MalReynolds@slrpnk.net 1 points 5 days ago (1 children)

Likely true, there are use cases, this is probably not one. Still, I like to go to 600 if varnishing.

[–] trilobite@lemmy.ml 2 points 5 days ago

Are therr any photos around?

[–] Nicadimos@lemmy.ml 2 points 5 days ago* (last edited 5 days ago)

That's exactly what I did. Cut a piece of wood to the length and angle I like and it perfectly matches the height of my keyboard since I made it. Just sanded smooth and put a light finish on it.