Woodworking

566 readers

1 users here now

founded 2 years ago

MODERATORS

pepsi@lemmy.world

Looking for advice: how do I waterproof wood (lemmy.world)

submitted 3 months ago by Jhex@lemmy.world to c/woodworking@lemmy.world

12 comments fedilink hide all child comments

So I park my snow blower in the garage and would like the snow residue to melt in place and not go all over.

I built this giant tray with a ramp so I can push the blower on it, that way the snow will stay on the tray.

I will caulk the seams and paint it with some resistant paint but I'll like to either glue a tarp on it, or some other plastic material or perhaps use some special coating so it lasts a few years.

The "floor" of the tray is OSB (aspenite?). Not the best for this is what I had and this project is more of an experiment for me.

Any recommendations?

you are viewing a single comment's thread
view the rest of the comments

[–] Jhex@lemmy.world 2 points 3 months ago (1 children)

Great idea!, I can easily add some feet for a gentle slant and poke a drain hole to go into a shallow tray on the side!!

[–] Assassassin@lemmy.dbzer0.com 2 points 3 months ago

Just make sure you take a little extra care with waterproofing the hole. If water leaches into the ply of the MDF, it'll rot it out from the middle before you even know what's happening. A little piece of plastic tubing going from the tray through the hole with some caulk to seal should do the trick. Put the end of the tube like 3mm below the surface of the ply to make sure water doesn't pool around it.