this post was submitted on 08 Feb 2026
15 points (100.0% liked)
VoronDesign
336 readers
1 users here now
lemmy.world community for VoronDesign 3D printers
founded 2 years ago
MODERATORS
you are viewing a single comment's thread
view the rest of the comments
view the rest of the comments
Did you figure out what was giving you those wild numbers?
Serious side, bed fan mod did a lot for chamber temps and recently started using some nano polymer adhesive on fr4 sheets, have had zero issues with warping even on large prints.
I was tightening a nozzle on a spare hotend and wanted to check it was hot enough while I did it. It was easiest to plug it into the chamber thermistor port. I realised it looked a bit silly and thought it was worth a post ๐
I genuinely do have trouble with sunlu abs coming unstuck. My chamber is 60ยฐC, and my parts are hard to remove from the bed when they don't warp, which I think suggests my build plate is good. Have you / are you using Sunlu abs?
Sunlu abs I haven't used, was using polymaker and a house brand of where I usually source parts from. Been using abs from Matter3D for a while now, haven't had much warping issues with that.
I've been using a super thin layer of this on my surfaces and haven't looked back. Buildtak works really well too.