VoronDesign

336 readers

1 users here now

lemmy.world community for VoronDesign 3D printers

founded 2 years ago

MODERATORS

Haribro@lemmy.world

Guys, I've finally stopped Sunlu ABS warping! (lemmy.world)

submitted 2 weeks ago by UnH1ng3d@lemmy.world to c/vorondesign@lemmy.world

6 comments fedilink hide all child comments

you are viewing a single comment's thread
view the rest of the comments

[–] UnH1ng3d@lemmy.world 2 points 2 weeks ago (1 children)

I was tightening a nozzle on a spare hotend and wanted to check it was hot enough while I did it. It was easiest to plug it into the chamber thermistor port. I realised it looked a bit silly and thought it was worth a post 😂

I genuinely do have trouble with sunlu abs coming unstuck. My chamber is 60°C, and my parts are hard to remove from the bed when they don't warp, which I think suggests my build plate is good. Have you / are you using Sunlu abs?

[–] morbidcactus@lemmy.ca 2 points 1 week ago

Sunlu abs I haven't used, was using polymaker and a house brand of where I usually source parts from. Been using abs from Matter3D for a while now, haven't had much warping issues with that.

I've been using a super thin layer of this on my surfaces and haven't looked back. Buildtak works really well too.