465
Screw rule
(lemmy.blahaj.zone)
you are viewing a single comment's thread
view the rest of the comments
view the rest of the comments
this post was submitted on 28 Jun 2023
465 points (100.0% liked)
196
16593 readers
2791 users here now
Be sure to follow the rule before you head out.
Rule: You must post before you leave.
founded 1 year ago
MODERATORS
I hate phillips. It seems like their only purpose for existing is to strip out so that you can never remove them.
Personally, any time I have a project, I always opt for torx (star). The screwdriver bits for them are not tapered so they don't push themselves back out of the screw-head (unlike phillips), so they tend to stay in place and grip much better. It's a lot harder to screw up a torx screw or bit than a phillips one.
They actually were designed to cam out in low torque applications so consumers could not over-tighten them. The problem is now those consumers only know what a phillips is, so they're used for everything.
Hilariously, that "purposeful cam-out" was the manufacturers/patent-holders trying to turn a bug into a feature. https://handwiki.org/wiki/Engineering:Cam_out