submitted 1 year ago by MeatballFlag to c/3dprinting@lemmy.world

7 comments fedilink hide all child comments

This print started fine the first handful of layers before I walked away. I came back later and everyone of these blocks was curling up with the corners lifting off the bed. I just put on the PEI plate, this is the first print on it. I did level the print bed manually with a sheet of paper, the first layers of each block looked nice and uniform. I'm printing with the bed at 60c which is what I've always used with the flexible magnetic print mat that came on the printer. Should I be turning down the bed temp with the PEI plate?

Thanks for any advice

you are viewing a single comment's thread
view the rest of the comments

[-] rambos@lemmy.world 3 points 1 year ago

As others said clean the surface, but also consider bit more squish on the first layer.

Changing bed surface is a big change and requires calibration. First PID tune your bed heater if you havent already. Then find new good temp for your setup (assuming everything else is fine). To be fair, pla and pei are both quite forgiving, but having printer dialed in is almost mandatory for large prints.

I dont use pei, but printing on clean glass. 60 C with fans off is perfect for 1st layer, but then I have to change it to 56 C to avoid corner lifting on large prints.

Also good practice is to leave printer heated for like 20 min before you start printing

[-] rambos@lemmy.world 2 points 1 year ago

Also some parts are harder to print, like 200 mm cube. Use all helpers whenever you can, brim is easy to remove and I use it 95% of time. Mouse ears are overkill sometimes, but I sleep better while printing big parts with sharp corners. Also waking up better when I know it didnt fail

this post was submitted on 17 Jul 2023

9 points (100.0% liked)

3DPrinting

15674 readers

51 users here now

3DPrinting is a place where makers of all skill levels and walks of life can learn about and discuss 3D printing and development of 3D printed parts and devices.

The r/functionalprint community is now located at: !functionalprint@kbin.social or !functionalprint@fedia.io

There are CAD communities available at: !cad@lemmy.world or !freecad@lemmy.ml

Rules

No bigotry - including racism, sexism, ableism, homophobia, transphobia, or xenophobia. Code of Conduct.
Be respectful, especially when disagreeing. Everyone should feel welcome here.
No porn (NSFW prints are acceptable but must be marked NSFW)
No Ads / Spamming / Guerrilla Marketing
Do not create links to reddit
If you see an issue please flag it
No guns
No injury gore posts

If you need an easy way to host pictures, https://catbox.moe may be an option. Be ethical about what you post and donate if you are able or use this a lot. It is just an individual hosting content, not a company. The image embedding syntax for Lemmy is ![](URL)

Moderation policy: Light, mostly invisible

founded 2 years ago

MODERATORS

j4k3@lemmy.world

andypiper@lemmy.world

henry_rowengartner@lemmy.world

GrayBackgroundMusic@lemm.ee