Hi folks. I obtained a pre-owned Anycubic Vyper. Alas, every print features defects in the surface as shown in the picture. It occurs in any type of material. Does anybody know the source of this type of defects?
this post was submitted on 11 Jul 2026
33 points (97.1% liked)
3DPrinting
23164 readers
34 users here now
3DPrinting is a place where makers of all skill levels and walks of life can learn about and discuss 3D printing and development of 3D printed parts and devices.
The r/functionalprint community is now located at: or !functionalprint@fedia.io
There are CAD communities available at: !cad@lemmy.world or !freecad@lemmy.ml
Rules
-
No bigotry - including racism, sexism, ableism, homophobia, transphobia, or xenophobia. Code of Conduct.
-
Be respectful, especially when disagreeing. Everyone should feel welcome here.
-
No porn (NSFW prints are acceptable but must be marked NSFW)
-
No Ads / Spamming / Guerrilla Marketing
-
Do not create links to reddit
-
If you see an issue please flag it
-
No guns
-
No injury gore posts
If you need an easy way to host pictures, https://catbox.moe/ may be an option. Be ethical about what you post and donate if you are able or use this a lot. It is just an individual hosting content, not a company. The image embedding syntax for Lemmy is 
Moderation policy: Light, mostly invisible
founded 3 years ago
MODERATORS
you are viewing a single comment's thread
view the rest of the comments
view the rest of the comments
Replace the resistor and temp sensor. I would also replace the hot end itself, at least for my printer it was like 10e
Weeeeeeell the last time when I tried to replace the hot end, I screwed up so hard the printer was not usable any more after that 😂
How...? Mine is literally 2 bolts and the bowden tube retaining bolt? Plus of course the sensor and resistor cartridge. I have no experience of direct feed hot ends tho.