3DPrinting is a place where makers of all skill levels and walks of life can learn about and discuss 3D printing and development of 3D printed parts and devices.
The r/functionalprint community is now located at: or !functionalprint@fedia.io
There are CAD communities available at: !cad@lemmy.world or !freecad@lemmy.ml
No bigotry - including racism, sexism, ableism, homophobia, transphobia, or xenophobia. Code of Conduct.
Be respectful, especially when disagreeing. Everyone should feel welcome here.
No porn (NSFW prints are acceptable but must be marked NSFW)
No Ads / Spamming / Guerrilla Marketing
Do not create links to reddit
If you see an issue please flag it
No guns
No injury gore posts
If you need an easy way to host pictures, https://catbox.moe/ may be an option. Be ethical about what you post and donate if you are able or use this a lot. It is just an individual hosting content, not a company. The image embedding syntax for Lemmy is 
Moderation policy: Light, mostly invisible
Hi all,
I'm doing an experiment with a cabinet for filament with a small dehumidifier in it. I can get it to sit at 35%, but not much lower. I've sealed the cabinet with foam tape, and dried most of the filament first.
Are there any tricks to help improve performance of the mini dehumidifier? Maybe adding more heat to the cabinet?
The goal would be to use Home Assistant and the humidity sensor to turn things on and off as needed.
Thanks!
While I'd rather have 2% accuracy than 5% on paper, it's been fine, and checking with higher quality sensor has always put me within 1%.
Also, I mentioned in another comment it was a peltier, and I'd love to do SS but just soooo expensive. :(