Machinist

1321 readers

3 users here now

From Newcomers to Old Timers, a community united by the Industry of Machining

Rules Don't post illegal stuff

Don't post Porn (no sexy aluminum surface finishes don't count)

Don't be an asshat (harassment, bullying etc.)

If you're going to post NSFW stuff, flag it as NSFW, It's ok to post shop Screwups (blood/cuts) just make sure to flag it as NSFW

and Finally make sure to have a good time :D

founded 2 years ago

MODERATORS

submitted 4 days ago by domdanial@reddthat.com to c/machinist@sh.itjust.works

you are viewing a single comment's thread
view the rest of the comments

[–] Nomecks@lemmy.ca 8 points 4 days ago (1 children)

Anvils last a long time even in the shittiest conditions. They're blocks of iron or steel and it's hard for rust to really penetrate deep

[–] domdanial@reddthat.com 3 points 4 days ago (1 children)

Also I'd already attacked it with a flap disk to get most of the surface rust off, it was pretty fuzzy when I started.

[–] Nomecks@lemmy.ca 3 points 4 days ago* (last edited 4 days ago)

Is it branded on the other side?