this post was submitted on 25 Feb 2026
48 points (100.0% liked)
Machinist
1321 readers
1 users here now
From Newcomers to Old Timers, a community united by the Industry of Machining
Rules Don't post illegal stuff
Don't post Porn (no sexy aluminum surface finishes don't count)
Don't be an asshat (harassment, bullying etc.)
If you're going to post NSFW stuff, flag it as NSFW, It's ok to post shop Screwups (blood/cuts) just make sure to flag it as NSFW
and Finally make sure to have a good time :D
founded 2 years ago
MODERATORS
you are viewing a single comment's thread
view the rest of the comments
view the rest of the comments
It's looks like it's in remarkably good condition for 30 years in a barn!
What comes next after machining the top?
Anvils last a long time even in the shittiest conditions. They're blocks of iron or steel and it's hard for rust to really penetrate deep
Also I'd already attacked it with a flap disk to get most of the surface rust off, it was pretty fuzzy when I started.
Is it branded on the other side?
I flipped it over actually, try to get the bottom parallel but I gave up after a few passes, it would have taken more than I was willing to cut.
Should put some nice chamfers and radii on the edges, you use the edge of an anvil a fair but, and being able to select a radius, chamfer, or square edge is nice.