Hi folks. I obtained a pre-owned Anycubic Vyper. Alas, every print features defects in the surface as shown in the picture. It occurs in any type of material. Does anybody know the source of this type of defects?
this post was submitted on 11 Jul 2026
37 points (95.1% liked)
3DPrinting
23202 readers
64 users here now
3DPrinting is a place where makers of all skill levels and walks of life can learn about and discuss 3D printing and development of 3D printed parts and devices.
The r/functionalprint community is now located at: or !functionalprint@fedia.io
There are CAD communities available at: !cad@lemmy.world or !freecad@lemmy.ml
Rules
-
No bigotry - including racism, sexism, ableism, homophobia, transphobia, or xenophobia. Code of Conduct.
-
Be respectful, especially when disagreeing. Everyone should feel welcome here.
-
No porn (NSFW prints are acceptable but must be marked NSFW)
-
No Ads / Spamming / Guerrilla Marketing
-
Do not create links to reddit
-
If you see an issue please flag it
-
No guns
-
No injury gore posts
If you need an easy way to host pictures, https://catbox.moe/ may be an option. Be ethical about what you post and donate if you are able or use this a lot. It is just an individual hosting content, not a company. The image embedding syntax for Lemmy is 
Moderation policy: Light, mostly invisible
founded 3 years ago
MODERATORS
you are viewing a single comment's thread
view the rest of the comments
view the rest of the comments
My guess would be hotend not feeling so good. Those white spots look like result of temperature changes.
If you can read hotend thermistor data somehow (OctoPrint, for example, shows a chart for that) and see lots of sudden ±2-5°C changes - that'd be it.
Yeah, that's what I observe in octoprint. Do you also know how to fix?
This might be thermistor losing contact with the block or wires losing contact. It can also be the heater wires losing contact somewhere. To diagnose, you can try and wiggle the wires when you preheat the hotend and watch the temps. Then you will know what needs replacing. I once had a thermistor that was faulty, I replaced it, the problem went away.
You can try running a PID tune on the nozzle and see if that helps.
Unfortunately, the temperature variation still is above 3° C.
Ok, I never heard of that and read into it. As this is there easiest thing to do, I'll do this ASAP and see of it works.
Replace the resistor and temp sensor. I would also replace the hot end itself, at least for my printer it was like 10e
Weeeeeeell the last time when I tried to replace the hot end, I screwed up so hard the printer was not usable any more after that 😂
How...? Mine is literally 2 bolts and the bowden tube retaining bolt? Plus of course the sensor and resistor cartridge. I have no experience of direct feed hot ends tho.
Guess I have been repeatedly too stupid to buy parts up to specs and then trying to solder them together, which failed. By that, I destroyed the original equipment and got no working replacement in place.