So people throw out disposable vapes all the time. I cracked one open to take a look and it turns out they have a 18500 battery in it. So I was thinking of 3D printing a spacer to make it the same size as a 18650 and putting some shrink wrap on them. I just wanted to see what people who know more than me think. Is this a bad idea that is going to burn my house down? a waste of time perhaps?

I did a trial run in my wurkkos fc11 and they seem to work, it charges and looks just as bright.

Going to make some chili and I've never stewed with it before. I feel like it would just turn into mush stewing for an hour. But if it holds up it would soak up all that flavor so idk if I should put it in at the start or the end.

4+ days?

I forgot what this one was.

I think this was a Chrysler Sebring, like an 04.

I forgot what this was one. I think they needed calipers.

Chevy Trailblazer. I wonder what the caster was.

IIRC it was a 2010 Escape

Does not run to bad, Using sodium and all the settings cranked to low. Stays over 60.

Purchased it on a lark, I thought I was going to have to do a lot of tinkering to get it usable but nope! Does all the basics perfectly. I've got some Mini display to HDMI cords that support 4k60 in the mail and that was my only gripe with it. Not a bad little system for the money.