this post was submitted on 22 Oct 2025
230 points (98.3% liked)

The Shitpost Office

647 readers
505 users here now

Welcome to The Shitpost Office

Shitposts processed from 9 to 5, with occasional overtime on weekends.

Rule 1: Be Civil, Not SinisterTreat others like fellow employees, not enemies in the breakroom.

  • No harassment, dogpiling, or brigading
  • No bigotry (transphobia, racism, sexism, etc.)
  • Respect people’s time and space. We’re here to laugh, not to loathe

Rule 2: No Prohibited PostageSome packages are simply undeliverable. That means:

  • No spam or scams
  • No porn or sexually explicit content
  • No illegal content
  • NSFW content must be properly tagged

If you see anything that violates these rules, please report it so we can return it to sender. Otherwise? Have fun, be silly, and enjoy the chaos. The office runs best when everyone’s laughing.... or retching over the stench, at least.

founded 3 months ago
MODERATORS
 
all 40 comments
sorted by: hot top controversial new old
[–] essell@lemmy.world 59 points 2 months ago (2 children)

Clean the fluff out of the port!

[–] Ethalis@jlai.lu 15 points 2 months ago (4 children)

A toothpick or a needle work very well

[–] essell@lemmy.world 9 points 2 months ago (1 children)

A "raw" staple can also be good, though sometimes you need more than one

[–] Schmuppes@lemmy.today 9 points 2 months ago* (last edited 2 months ago) (1 children)

I use a scalpel with the non-sharpened side of the blade to scrape the debris to the side and then blast it out with an air compressor. All the things I used before that were not pointy and thin enough to get inside the port.

[–] ThePantser@sh.itjust.works 15 points 2 months ago

The best I found was a plastic tooth flossing pick. Use the pointy side. It's non conductive to prevent shorting of pins.

[–] swagmoney@lemmy.ca 2 points 2 months ago

i like to snap the toothpick so it splits on an angle. that way it's narrower and the jagged edges grab onto the dust and crap

[–] ChairmanMeow@programming.dev 2 points 2 months ago

Needles are much better for this, with toothpicks you might damage the sides or leave splinters behind in the port.

[–] masquenox@lemmy.dbzer0.com 1 points 2 months ago

Those plastic fishbone toothpicks works wonders for anything small and electronic.

[–] Live_your_lives@lemmy.world 4 points 2 months ago (1 children)

If cleaning out the port with a stick still doesn't work, try using a small amount of a high percentage isopropyl alcohol and a toothbrush to clean out the port. It's done wonders for me.

[–] essell@lemmy.world 1 points 2 months ago

Works for both phones and ears.

[–] Mangoguana@lemmy.world 29 points 2 months ago* (last edited 2 months ago) (2 children)

Step 1: get wooden toothpick

Step 2: sharpen toothpick (unless smoll enough)

Step 3: patiently remove all the wool/dust/fiber in the charge hole. It looks like belly button lint.

Step 4: your usb works again, and you didn't need to change your 1000$ phone ffs

[–] hobovision@mander.xyz 19 points 2 months ago (1 children)

Step 3 is actually break off the toothpick in the port.

Step 4 is find that tiny sewing needle someone got you in a little sewing kit as a gift as if your not some kind of goblin.

Step 5 wow this needle works great why did I think putting a literal splinter into my phone's charge port was a good idea?

[–] Mangoguana@lemmy.world 1 points 2 months ago

Metal bad for gold, wood breaks but does not scratch metal. Plastic works too but ive had more success with wood since i can shape it

[–] LastYearsIrritant@sopuli.xyz 11 points 2 months ago (1 children)

Plastic disposable dental picks work better.

https://www.cvs.com/shop/cvs-advanced-floss-picks-90-ct-prodid-454381

Perfect size to clean out a USB port without any chance of a short, and they're crazy cheap.

[–] whelk@retrolemmy.com 4 points 2 months ago

Holy smokes, this actually worked! Still like my wireless charger but dang it'll be nice to charge at places without one again

[–] davetortoise@reddthat.com 16 points 2 months ago

99% of the time this is caused by dust/blockage in the charging port! If your phone uses USB-C charging its very easy to clean with a needle without causing any damage.

[–] But_my_mom_says_im_cool@lemmy.world 11 points 2 months ago* (last edited 2 months ago) (1 children)

Get a little pin or toothpick and start digging at the charger port, you’ll be surprised at how much lint and gunk get in there from your pocket. Enough to prevent the charger from popping in fully. Also most times you need a new cord

Mine looked like this when I dug in there

[–] rbesfe@lemmy.ca 2 points 2 months ago (1 children)

Aka start digging in your (phone's) butt twin

[–] RichardDegenne@lemmy.zip 3 points 2 months ago
[–] FireRetardant@lemmy.world 9 points 2 months ago (1 children)

Mine did something similar where i often get false wet charger alarms and more often than not it doesnt charge or give me an alarm at all now. Luckily wireless charging seems to work consistently for now but i guess i should consider finding a new phone soon.

[–] meekah@lemmy.world 7 points 2 months ago (3 children)

pro tip: use wireless charging as much as possible, even when USB is still working

not only does it make your USB port last longer, due to the lower amperage when charging wirelessly, it also helps battery longevity!

[–] princessnorah@lemmy.blahaj.zone 8 points 2 months ago (1 children)

From everything I've read, wireless charging and the heat it causes harms battery longevity, not helps it.

[–] TriplePlaid@lemmy.zip 4 points 2 months ago

Also it is important to know that wireless charging is much less efficient and therefore is environmentally worse than using a corded charger.

[–] brap@lemmy.world 7 points 2 months ago (1 children)

Oh yes. Wireless charging next to the bed and wireless charging quadlock in a vehicle. But mainly because my toddler likes grabbing wires.

[–] Rooster326@programming.dev 3 points 2 months ago* (last edited 2 months ago) (1 children)

While I've done the same with wireless charging everywhere.

Get magnetic USB cables they break off in case of a snatch.

It will save you a huge headache one day.

Then later on they use the cables to charge whatever old device you gave them. Make them responsible for charging their own devices - which would be very dangerous with a real USB connector.

[–] brap@lemmy.world 1 points 2 months ago

Didn’t even realise that was a thing. Will look into that, cheers.

[–] GissaMittJobb@lemmy.ml 3 points 2 months ago

If you're looking to limit the charging speed, wouldn't it be better to limit it using software with a cable plugged in?

I can't say that I've ever felt that port longevity is a concern.

I'm not fond of wireless charging as the device is essentially useless while charging, which is not true if you have a sufficiently long cable when charging. Iirc the energy efficiency of wireless charging is also lower than by cable

[–] 5inister@reddthat.com 6 points 2 months ago (1 children)

I cut old credit cards into tiny hooks and wedges to remove lint, hair, fluff, and whatever else from the charging port because I'm scared of shorting the USB pins with a metal needle.

[–] Raiderkev@lemmy.world 2 points 2 months ago (1 children)

Keyboard duster cans exist

[–] Ashen44@lemmy.ca 1 points 2 months ago

A lot of it is packed in from the charger shoving it down there, compressed air won't get that out.

[–] joyjoy@lemmy.zip 5 points 2 months ago

At least you can still buy a new charger. Wait until your folding phone will only charge when the phone is at a certain angle.

[–] Ilovethebomb@sh.itjust.works 4 points 2 months ago

I use wireless charging as much as possible for this very reason.

[–] lka1988@lemmy.dbzer0.com 3 points 2 months ago (1 children)

What in the hell are you guys doing to get that amount of lint in your charge port? Every phone I've had in the last decade has been USB-C, yet I've never had that level of buildup.

[–] WALLACE@feddit.uk 6 points 2 months ago (1 children)

It happens if it spends a lot of time upside down in your pocket and you do a lot of moving/walking

[–] lka1988@lemmy.dbzer0.com 1 points 2 months ago

...which is like 90% of the conditions my phone sees 😂

[–] FooBarrington@lemmy.world 3 points 2 months ago (1 children)

That's why I bought a phone with two USB-C ports 😎

[–] Honytawk@feddit.nl 3 points 2 months ago

That is why I bought a Fairphone, where I can replace the USB-C port myself for 15€.

[–] renrenPDX@lemmy.dbzer0.com 2 points 2 months ago

I’ve seen the use of hot glue gun in charge port then removed once slightly cooled on YT repair channels. Never tried but might be worth looking into.